Advidia "A" Series Uživatelský manuál stáhnout pdf (Strana 5)

Firmware User Manual

Preparation

Connect the Equipment

To be able to connect to the camera firmware from your PC, both the camera and the PC have to be

connected to each other via Ethernet cable. At the same time, the camera must have its own power

supply. In case of PoE cameras, you can use a PoE Injector or a PoE Switch between the camera and the

PC. The cameras that have the DC power connectors may be powered on by using a power adapter.

The Ethernet port LED or Power LED of the camera will indicate that the power supply for the camera

works normally.

Configure the IP Addresses

In order to be able to communicate with the camera from your PC, both the camera and the PC must be

within the same network segment. In most cases, it means that they both should have very similar IP

addresses, where only the last number of the IP address is different from each other. There are 2

different approaches to IP Address management in Local Area Networks – by DHCP Server or Manually.

Using DHCP server to assign IP addresses:

If you have connected the computer and the camera into a network that has a DHCP server running, then

you do not need to configure the IP addresses at all – both the camera and the PC would request a

unique IP address from DHCP server automatically. In such case, the camera will immediately be ready

for the access from the PC. The user, however, might not know the IP address of the camera yet. It is

necessary to know the IP address of the camera in order to access it by using a Web browser.

The quickest way to discover the cameras on the network is to use the network search feature, built

into the Windows operating system – just by pressing the “Network” icon, all the cameras of the local

area network will be discovered by Windows thanks to the UPnP function support of our cameras.

1 2 3 4 5 6 7 8 9 10 ... 111 112

Žádné komentáře

Advidia "A" Series Uživatelský manuál Strana 5